Project Tamriel

Home to a Nord commoner family.

Use t_imp_furnsky and t_nor_furnM.

Location number 12 on this map:



The exterior can be found here (use the latest file)

I will start working on this.

Very good! Grant.

This should be one floor with a basement.

First time with this tile set if you could check it for me, thx.

Looks good but on the far wall where you are overlapping pillars in the wall, instead use T_Rga_SetReach_I_TileTrim_01s rather than 02s, as they come with the 'middle' bit of pillar to make a seamless transition between the upper and lower walls.

Otherwise looks great, well done for remembering to add the corner pillars.

Using that tile trim keeps the upper and lower levels in the right place, it revealed that the basement skirting boards had been hidden when i moved the walls up to meet the tiletrim_01s beam connector. The example rga build in data doesn't have the corner pieces but another example i looked at luckily did

Please check my attached file, it will show you how to use these transition trim pieces effectively.
You will need to move your basement up 2 clicks on the gridsnap

Sorry my last message was a bit convoluted what I mean to say is I used the piece you suggested and it made everything fit perfectly

But thank you for taking the time to make the example.

Ah sorry, thought you meant that you had just left it B) Oh well, nothing to worry about then! Keep up the good work!

So sorry but I must abandon this claim and withdraw from the project

Sorry to hear that! Hope all is well. Do you have a WIP file?

Shall I pick this up?

Please do!

Voila, mes amis. The bit I'm not completely happy with is how wide the downstairs bedroom is. I'll happily take suggestions before putting it up for review.

Alright, this one's ready for review.

Moved to reviewing.

Merged with Section File.